Multifunction Diagnostic Panel Mount Calibrator – PIE 830PM

Calibrator functions include:

• Calibrate milliamps and voltage
  Source 0.00 to 24.00 mA, 0.00 to 10.25 VDC and 0.00 to 80.00 mV
  Read to 24.00 mA, 00.00 to 10.,25 VDC, 0.0 to 60.0 VDC, 00.00 to 80.00 mV
  Simulate 2 Wire transmitters
  Power up transmitters and loops with built in 24 V power supply
  Simplify HART hook ups with built in 250 ohm resistor
• Calibrate directly in temperature (°C & °F)
  Thermocouple types J, K, T, E, R, S, B, N, G, C, D, L (J DIN), U (T DIN) and P(Platinel II)
  RTD types Pt 100 Ohm (3850, 3902, 3916, 3926) & 1000 Ohm (3850)
  Copper 10 & 50 Ohm, Nickel 110 and 120 Ohm
  Resistance up to 4010 ohms
• Checkout flow and vibration systems
  Source & read frequency to 2000 CPM (Counts-Per-Minute), 999.99
  Hz, 9999.9 Hz, 20.000 kHz
• Source pH signals to calibrate pH transmitters and instruments
  Source from 0.000 to 14.000 pH @ 25°C (77°F) corresponding to +414.12 to -414.12 mV
• Measure pressure with optional pressure modules
  32 modules for gauge, differential, compound and absolute pressure
• Two isolated channels allow you to calibrate transmitters, PLC’s and other instruments with one unit

Calibrator features include:

• Value added troubleshooting features of the PIE 830PM
  Patented diagnostics including Current Leak detection;  LOOPSCOPE which indicates loop current, voltage and resistance
  Auto detection of RTD connections
  Ability to operate as an Isolated Transmitter
• Technician friendly operation
  Intuitive EZ-DIAL double click menu makes it easier to setup than other multifunction calibrators. Uses the same menus as our hand held models
• Quickly set any three outputs plus automatic stepping & ramping
  Set any value quickly with the adjustable EZ-DIAL; store any three output settings for instant recall with the EZ-CHECK switch
  Choose between 2, 3, 5 & 11 steps to automatically increment the output in 100%, 50%, 25% or 10% of span
  Select RAMP to smoothly increase and decrease the output between Zero and Span
  Set step/ramp time to match your system from 5, 6, 7, 8, 9, 10, 15, 20, 25, 30 and 60 seconds
• Easily recall stored values
  Use the EZ-CHECK™ switch to recall the HI and LO values automatically stored when in READ mode