Multifunction Process Calibrator PIE 820 | 6 functions in 1 calibrator
Multifunction Process Calibrator – mA • V • TC • Ohms • RTD • Hz
Lighten up your toolbox
Pocket sized calibrator replaces toolbox of single function devices
Technician friendly operation
Intuitive EZ-DIAL double click menu makes it easier to setup than other multifunction calibrators. Uses the same menus as the single function PIE Evolution calibrators. Icons on the display indicate where to plug in the test leads.
Use it as a milliamp and voltage calibrator
Source 0.00 to 24.00 mA, 0.00 to 10.25 VDC and 0.00 to 80.00 mV
Read to 24.00 mA, 00.00 to 10.,25 VDC, 0.0 to 60.0 VDC, 00.00 to 80.00 mV
Simulate 2 Wire transmitters
Power up transmitters and loops with built-in 24 V power supply
Simplify HART hook ups with built in 250 ohm resistor
Calibrate directly in temperature (°C & °F)
The PIE 820 works with the instruments you use.
Thermocouple types J, K, T, E, R, S, B, N, G, C, D, L (J DIN), U (T DIN) and P(Platinel II)
RTD types Pt 100 Ohm (3850, 3902, 3916, 3926) & 1000 Ohm (3850)
Copper 10 & 50 Ohm, Nickel 110 and 120 Ohm
Checkout flow and vibration systems
Source & read frequency to 2000 CPM (Counts-Per-Minute), 999.99
Hz, 9999.9 Hz, 20.000 kHz
Troubleshoot loop & wiring problems
Beep out connections with the built-in continuity checker
Easy to read
Turn on the backlight & easily see the display in dark areas of the plant
Quickly set any three outputs plus automatic stepping & ramping
Easily set any value quickly with the adjustable EZ-DIAL; store any three output settings for instant recall with the EZ-CHECK switch.
Choose between 2, 3, 5 & 11 steps to automatically increment the output in 100%, 50%, 25% or 10% of span.
Select RAMP to smoothly increase and decrease the output between Zero and Span.
Set step/ramp time to match your system from 5, 6, 7, 8, 10, 15, 20, 25, 30 and 60 seconds
Includes Rubber Boot, Deluxe Hands Free Carrying Case & mV/RTD Test Leads (020-0820)
Advantages of the PIE 820 over the Altek 820 multifunction calibrator
Automatic stepping and ramping
Setp 2,3,5 & 11 steps or continuous ramp from 5 to 60 seconds to match your test procedures
Larger Display with Backlight
Easy viewing in dark locations. Icons on display indicate where to plug in test leads.
More Resistant to Accidental Damage
Rubber boot and stronger switches
More thermocouple and RTD ranges with .1 degree resolution and better accuracy
Compatible with smart transmitters, multichannel recorders, PLC’s and DCS’s
Smaller and 25% lighter
Pocket sized and easier to carry
LED for optical pickups
LED flashes green in synch with frequency output. Illuminates red for overload conditions.
Includes Certificate of Calibration
All PIE Calibrators come with a free signed and dated certificate. Altek’s come only with an unsigned Statement of Calibration Practices with a certificate of calibration available for an extra charge.