Altek 334 Milliamp calibrator – no longer in production!
The Altek 334 was designed back in 1988 and the updated Altek 334A in 1998. The PIE 334 matches the Altek in fit, form and function with a few features bringing the design into the 21st century. It has a rubber boot and lower profile switches for protection in the field and a backlit display making it easier to use in the dark corners of your plant. Instead of the three expensive 9V batteries in the Altek the PIE uses four less expensive common “AA” batteries. The PIE has the same resolution and accuracy as the Altek with longer battery life letting you calibrate more instruments between battery changes.
Advantages of the PIE 334 over the Altek 334 and Altek 334A milliamp loop calibrator
- Backlit Display with Larger Digits
Easier to read in dark areas of the plant
- More Resistant to Accidental Damage
Rubber Boot and Stronger Switches
- Separate Battery Compartment with 4 “AA” Batteries
No more removing housing with screwdriver to replace three expensive 9V batteries. Calibration seals remain intact.
- Calibrate More Devices Between Battery Changes
Drives more loop instruments at 24 Volts (up to 1200 Ohms) for entire battery life. The Altek 334 output voltage drops as the batteries run down.
- Includes Certificate of Calibration
All PIE Calibrators come with a free signed and dated certificate. Altek calibrators come only with an unsigned Statement of Calibration Practices with a certificate of calibration available for an extra charge.
Looking for more than just an Altek 334 replacement?
The PIE 334Plus does everything the Altek 334 or PIE 334 can do with higher resolution and simple to use loop troubleshooting features. Calibrate smart transmitters with the built-in 250 Ohm resistor for HART® compatibility, high resolution to 0.001 milliamp and the the ability to check loop power supplies or batteries with built-in DC Voltage measurement range. Save time troubleshooting loops by using the Advanced Loop Diagnostics to find hidden loop problems caused by moisture and corrosion in junction boxes. This feature is only found in PIE Calibrators!
Altek 334 & 334A
Why choose a PIE 334 or 334Plus instead of some other brand of milliamp calibrator? We are the same team that designed the Altek 334 and the Altek 334A and no other manufacturer has as much milliamp calibrator experience as PIE. PIE also manufactures a complete line of milliamp, voltage, thermocouple, RTD and frequency single function calibrators as well as multifunction calibrators matching and surpassing the Altek line of handheld calibrators.
When it is time for service on your Altek milliamp calibrator PIE has the most experience in calibration and repair of Altek electronic calibrators. Or, if it is time to upgrade or replace a failing Altek 334 calibrator, we offer a discount on a new PIE calibrator similar to the Altek that you are replacing – in working or non working condition! Click for repair and calibration pricing.
Replacing a different Altek Calibrator? Click Altek Calibrator Replacements or download the complete Altek Calibrator Replacement Guide